Smith & Nephew LENS Integrated System, Руководство по эксплуатации и обслуживанию

Страница: 15 / 48

15
10601034 Rev. B
LENS Integrated System Operations/Service Manual
Installation
Recommended System Configuration for the
Wi-Fi-Enabled System
This section explains the recommended equipment connections for
optimum performance. Perform this procedure each time that the
System is installed or reconfigured.
Required Equipment:
• LENS Camera Control Unit, Wi-Fi-enabled (REF 72204354)
• LENS Camera Head
• Wi-Fi Antenna
• HD Flat Panel Display
Optional Equipment:
• iPad and App
• USB storage device. The USB can be connected to either the USB
port on the front panel or the port on the rear panel of the control
unit.
Procedure
Note: For best image, use a HD-DVI signal (control unit output to
monitor input). A direct connection between the control unit and a high
definition monitor will always produce the highest quality image.
Note: It is strongly suggested that a minimum of two outputs be
connected at all times to provide a back-up signal if necessary.
1. Attach the antenna.
2. Connect the supplied hospital-grade power cord to the power
receptacle on the control unit’s rear panel.
3. To record still or video images from the camera, connect the App to
the LENS Wi-Fi network or a insert a USB storage device in one of
the USB ports on the control unit. Refer to the App IFU for details.
4. Connect the supplied hospital-grade power cord to the power
receptacle on the flat panel display and plug it in.
5. If the flat panel display has a termination switch, set it to the 75U or
ON position.
6. After connecting all components, including the camera head, turn
the video components on using the appropriate power switches.
Once the Wi-Fi-enabled System has been turned on, the iPad can be
connected using the App. If using the non-Wi-Fi version of the System,
the iPad and App cannot be used.
Configure the peripheral ports
The default settings for the peripheral ports on the rear of the control
unit are FRAME CAPTURE (Port 1, or the top port) and VIDEO CAPTURE
(Port 2, or the bottom port. Each of the peripheral control ports can
be configured for FRAME CAPTURE, GENERAL PURPOSE, or VIDEO
CAPTURE. For information on how to customize the peripheral ports,
refer to the “Configure Peripheral Ports” section of this manual.
Note: A USB device, iPad
T
, and 660HD Image Management System are
not required in order to use the System.