Smith & Nephew LENS Integrated System, Руководство по эксплуатации и обслуживанию

Страница: 43 / 48

43
10601034 Rev. B
LENS Integrated System Operations/Service Manual
Electromagnetic Tables
Electromagnetic Tables
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
The Smith & Nephew LENS Integrated System is intended for use in the electromagnetic environment specified below. The customer or user of the
LENS Integrated System should assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment – Guidance
RF emissions
CISPR 11 Group 1
The
LENS Integrated System
uses RF energy only for its internal functions.
Therefore, its RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
CISPR 11 Class A The LENS Integrated System is suitable for use in all establishments other than
domestic and those directly connected to the public low-voltage power supply
network that supplies buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2 Not applicable
Voltage fluctuations/flicker
emissions
IEC 61000-3-3
Not applicable
Guidance and Manufacturer’s Declaration – Guidance for Separation Distances
Recommended Separation Distances Between Portable and Mobile RF Communications Equipment and the
Smith & Nephew LENS Integrated System
The LENS Integrated System is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer
or user of the LENS Integrated System can help prevent electromagnetic interference by maintaining a minimum distance between portable and
mobile RF communications equipment (transmitters) and the LENS Integrated System as recommended below, according to the maximum output
power of the communications equipment.
Rated Maximum Output Power
of Transmitter (W)
Separation Distance According to Frequency of Transmitter (m)
150 KHz to 80 MHz
d = 1.2
√
P
80 MHz to 800 MHz
d = 1.2
√
P
800 MHz to 2 .5 GHz
d = 2.3
√
P
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.2 1.2 2.3
10 3.8 3.8 7.3
100 12 12 23
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be estimated using
the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according
to the transmitter manufacturer.
Note 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures,
objects, and people.