-49-
No. JXC
※
-OMT0002-C
9.2 Basic parameter
The “Basic parameter” is the data to define the operating conditions of the controller, conditions of the
actuator, etc.
Activation: “XX” = Become effective just after storing in the controller
“X” = Become effective after restarting the controller
“-“ = The parameter cannot be changed (fixed value).
Description
Input range
Explanation
Write
Controller ID
Fixed value
This is a fixed value for this controller. Do not change the setting.
-
)
Note1)
Define the positive (+) limit of the position. [Unit: mm]
Any value greater than the [)] value cannot be entered in the
“Position” field data of the step data setup.
XX
Stroke(-)
Note1)
Define the negative (-) limit of the position. [Unit: mm]
Any value less than the [stroke(-)] value cannot be entered in the
“Position” field data of the step data setup.
XX
Max speed
Note1)
Define the maximum limit of speed. [Unit: mm/s]
Any value greater than the [Max speed] value cannot be entered in the
“Speed” field data of the step data setup.
-
Max ACC/DEC
Note1)
Define the maximum limit of acceleration or deceleration. [Unit
:
mm/s
2
]
Any value greater than the [Max ACC/DEC] value cannot be entered in
the step data.This setting also defines the deceleration when the
actuator is stopped by the
“HOLD” and “RESET” signals.
-
Def In position
Note1)
Set the INP output range to Origin Position after a Return to Origin.
[Unit: mm]
XX
ORIG offset
Note1)
Define the position of the actuator after the Return to origin operation.
[Unit: mm]
Caution
If the value for the “ORIG offset” is changed, the “Stroke (+)” and
“Stroke (-)” in the basic parameters should be checked.
XX
Max force
Note1)
Set the maximum possible force for "Pushing Force" in the profile
parameters.
XX
Option 1
Fixed value
This is a fixed value for this controller. Do not change the setting.
-
Note1) The range varies depending on the actuator. Refer to the actuator operation manual for more details.
■ The ORIG offset is 0 (mm)
■The ORIG offset is 100 (mm).
In the examples on the left, the
actuator positions are not
different but the reference point
that the controller recognizes will
be changed after the Return to
origin operation.
Controller recognizes position after
return to home position (0mm)
Controller recognizes
Position after return to home
position (100mm)
M
M
Actuator
Actuator
