HGM8110A/8120A Genset Controller User Manual Page 52 of 57
10
COMMISSIONING
Please make the under procedures checking before commissioning,
1.
Ensure all the connections are correct and wires diameter is suitable;
2.
Ensure that the controller DC power has fuse, controller’s positive and negative connected to
starting battery are correct;
3.
Emergence stop must be connected with positive of starting battery via scram button’s normal
close point and fuse;
4.
Take proper action to prevent engine to crank disconnect (e. g. Remove the connection wire of fuel
valve). If checking is OK, make the starting battery power on; choose manual mode and controller
will executive routine;
5.
Set controller under manual mode, press “start” button, genset will start. After the cranking times
as setting, controller will send signal of Start Failure; then press “stop” to reset controller;
6.
Recover the action of stop engine start (e. g. Connect wire of fuel valve), press start button again,
genset will start. If everything goes well, genset will normal run after idle running (if idle run be set).
During this time, please watch for engine’s running situations and AC generator’s voltage and
frequency. If abnormal, stop genset running and check all wires connection according to this
manual;
7.
Select the
AUTO
mode from controller’s panel, connect mains signal. After the mains normal delay,
controller will transfer ATS (if fitted) into mains load. After cooling time, controller will stop genset
and make it into standby status until there is abnormal of mains;
8.
When mains is abnormal again, genset will start automatically and enter into normal running, then
controller sends signal to make generator switch on, and control the ATS as generator load. If not
like this, please check ATS’ wires connection of control part according to this manual;
9.
If there is any other question, please contact Smartgen’s service.
