SMART Board SmartBoard 600i2, Конфигурация и руководство пользователя

Страница: 5 / 74

WARNING
• If the projector is mounted on the arm, the manufacturer recommends contacting your
authorized SMART reseller when the lamp must be exchanged.
• Only qualified personnel should replace the projector lamp. Replacing the lamp in a
arm-mounted projector might result in a fall and injury.
• If you continue to use the projector after the replacement message appears, the lamp might
shatter or burst, scattering glass throughout the projector head.
• If the lamp has shattered or burst, do not touch the glass fragments because they might
cause injury. Leave and then ventilate the area where the lamp shattered or burst. Wash
your hands thoroughly if you have come into contact with lamp debris. Thoroughly clean the
area around the projector, and discard any edible items placed in that area because they
might be contaminated.
• If the lamp has shattered or burst, call a SMART authorized service representative for
instructions. Do not attempt to replace the lamp.
• Remove the projector from the arm before servicing the lamp.
• Complete the procedure described in this document before following the instructions
included in your replacement lamp box.
• Uncovering the lamp while the projector is mounted on an arm might lead to product damage
or personal injury from falling pieces of glass if the lamp is broken.
• Turn the projector off and wait 15 minutes for the lamp to cool completely before removing
the old lamp assembly.
• Wear protective eyewear while changing the lamp. Failure to do so can cause injury or loss
of eyesight if the lamp shatters or bursts.
• The lamp used in the Unifi 45 projector contains mercury. Recycle or dispose of it as
hazardous waste, in accordance with local regulations.
• To prevent premature lamp failure or exposure to mercury, always handle the fragile lamp
assembly with care. Use gloves when touching the lamp. Do not touch the lamp with your
fingers.
• Use only the SB20 replacement lamp (SMART Part No. 01-00247).
• Never replace the lamp assembly with a previously used lamp assembly.
• When mounting the projector on a framed wall, you must attach both the mounting bracket
and safety tether to a stud to safely support the projector’s weight. If you only use drywall
anchors, the drywall can fail, resulting in product damage and possible personal injury.
• If the two screws supporting the safety tether are removed, the projector boom will be free to
swing. Make sure that these two screws are tightened and never remove them from the unit
without supporting the projector arm first.
• Two people are required to mount the projector and the interactive whiteboard on a wall
because they might be too heavy for one person to maneuver onto their wall-mounting
brackets.
• Cleaning a arm-mounted projector may result in a fall and injury.
99-00850-21 B0 Important Information iii