Advanced commissioning
7.6 Basic positioner and position control
Converter with control units CU250D-2
208
Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
Programming traversing blocks
Precondition
1.
You have selected the "Traversing blocks" screen.
2.
You select the "Program traversing blocks" button.
Procedure
To program the traversing blocks, proceed as follows:
1.
Assign a unique number for each traversing block.
2.
Define the command and the corresponding parameters.
3.
Set the job-specific values.
4.
Define the step enabling condition for the next job.
5.
If you travel to a fixed stop, a button appears to make additional settings for this function.
See also section: Travel to fixed stop (Page 213).
6.
Click this button to interconnect the status signals of the traversing blocks, for example,
with bit 10 and 11 of the positioner status word with the fieldbus.
7.
When you have programmed all traversing blocks, close the screen.
You have programmed the traversing blocks.
