Shini SGS-6080S, Руководство по эксплуатации

Страница: 71 / 77

71(77)
Attention!
Carefully inspect cutters, pushing block, screws, cutter rest and main
shaft during blade replacement for any damage.
6.2 Transmission
6.2.1 Maintenance for V-belt
Press emergency stop and turn off power switch before maintenance or
repair!
Shredder is equipped with four conveyor belts based on motor power.
1) Inspect cog belt
Inspect cog belt tension and running state after 20~30 full load operation.
Also check cog belt wear condition once in a month.
2) Inspect cog belt tension every six month
Open side plate of control cabinet, rotate cog belt for several circles and
inspect if there is wear or damage.
Attention!
Never put your hands between belt and pulley, otherwise it will cause
crushing injuries!
Inspect belt tension and adjust it if necessary. Check tension by applying force
(75N) at the middle of pulley then measure offset. (Distance of offset depends
on motor power and frequency, below is specifications):