Shini SGS-6080S, Руководство по эксплуатации

Страница: 53 / 77

53(77)
4) Put taper sleeve into pulley round hole, match hole sites with pulley and
screw inner hex bolts.
5) Adjust pulley via dial indicator, fit indicator tightly with pulley and rotate pulley
to check if indicator within 0~0.1mm.
Picture 3-6: Installation of Main Cutter Shaft and Bearing 2
6) After adjusting, fasten 3 inner hex bolts in loop with the torque 150Nm.
7) Mount pulley on motor shaft.
8) Put taper sleeve into pulley round hole, match hole sites with pulley and
screw inner hex bolts (M10mm
×
25, torque 45 Nm).
9) Place motor on fixing plate and push it forward to shorten distances between
pulley.
10) Adjust pulley: put a level bar in the middle of two pulleys, observe if mercury
column stays in the middle. If not, adjust pulleys to make them balanced.
11) Mount pulley, push motor to the right, twist adjusting screws to spread
forces on pulley evenly then tighten pulley and fasten adjusting bolts.
12) Mount motor shield and motor baffle.
Picture 3-7: Installation of Main Cutter Shaft and Bearing 3