Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 43 / 48

- 40 -
Symptom Possible Causes Remedy
Engine cannot
obtain high speed.
1
．
Idle control switch is set to
"ECO" .
2
．
Current of device using the
equipment as AC power source
is 1 A or less.
1
．
Set to
"AUTO" or "HIGH" .
2
．
Idle control switch is set to
"HIGH" .
Engine cannot
obtain low speed.
1
．
Idle control switch is set to
"HIGH".
2
．
Welding cable short circuit
1
．
Set to "ECO" or "AUTO" .
2
．
Remove the cause of the short
circuit.
Weld output
cannot be
adjusted by
remote controller
1
．
Connect the AC power source
into the remote controller
connection. 1
．
Disconnect the AC power source
VRD does not
work.
1
．
VRD switch is set to
"OFF" .
1
．
Set to
"ON" .
■
Error Code Display
Error codes are displayed on the DC
meters when the control board detects
an error. If the error code is displayed,
follow to the procedures in the
"Remedy".
Error Code Symptom Remedy
“
E01
”
Overheating
of control
parts for
welding
Set the idle control switch to "ECO" or "AUTO".
Run the engine to cool it down at idle under no-load until the
"E01" display disappears.
* This error is automatically resolved when temperature of the
control parts lowered to normal.
“
E03
”
Short circuit
of weld
output
Stop the engine.
Return the short circuit of the weld output and restart the engine.
<<<<
Note
>>>>
•
Maintenance of this equipment must be performed by specialized technicians.
•
When performing maintenance with doors or covers open, be sure that no other
persons can accidentally come close to the equipment. Close all doors and covers
if momentarily leaving the equipment unattended.
•
A simple inspection cannot always resolve some problems. If you cannot resolve a
problem after inspecting the equipment, request repair at the retail outlet where the
equipment was purchased.
Error Code Display