Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 24 / 48

- 21 -
6-5
．
． ．
．
Inspection for Fuel/Oil/Cooling Water Leakage
Warning: Fire
•
Absolutely never use the equipment if there is a fuel, oil or cooling water
leak, and be sure to always repair the leak before using.
Open the side door and check for fuel leakage from fuel line joints and similar
components, and check for oil and cooling water leakage. Open the fuel tap to
perform inspection and close it after inspection has been completed.
6-6
． ． ． ．
Battery Inspection
Warning: Injury to Eyes and Skin
•
Use protective gear, such as rubber gloves, when inspecting or replacing
the battery due to the dilute sulfuric acid in the battery fluid. Be sure that
fluid does not get into eyes, or on skin or clothing.
•
If battery fluid gets into the eyes, or on the skin or clothing, immediately
wash with a large amount of water, and always be especially sure to
seek medical attention if it gets into the eyes.
Warning: Explosion
•
Do not operate the equipment or recharge the battery when the battery
fluid level is below the lower level.
•
Do not generate any sparks near the battery and do not allow any fire or
other open flame near the equipment because the battery generates
ignitable gas.
1) Inspect the battery fluid level. If it is near
the lower level, add distilled water until it
reaches the upper level.
2) Inspect for loose terminals and retighten
if loose.
<<<<
Note
>>>>
•
It is necessary to recharge the battery when the specific gravity of the battery fluid
is 1.23 or less. Contact the retail outlet where the equipment was purchased if this
occurs.
■
Battery Replacement Procedures
1) Remove the "
－
" (negative)cable.
（
Always be sure to first remove
the"
－
" (negative) side.
）
2) Remove the battery hold-down
clamp.
3) Remove the "
＋
" (positive) cable.
4) Remove the battery.
* Install the battery by performing the above procedures in reverse order.
（
Always
be sure to first attach the "
＋
" (positive) side.
）
<<<<
Note
>>>>
•
Use the specified battery.
＜
46B24L
＞
(Japanese Industrial Standard)
UPPER
Level
LOWER
Level
Terminal
"
－
" Post
Hold-Down
Clamp
"
＋
" Post
Ins.Cap