Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 37 / 48

- 34 -
4) Screw in the oil filter by hand and securely tighten by hand (do not use a filter
wrench) after the gasket contacts the seal surface.
5) Add engine oil.
<<<<
Note
>>>>
•
Contact the retail outlet where the equipment was purchased if you do not have a
filter wrench.
•
Oil filter part no.: 15853-32436 (Kubota part no.)
•
After adding engine oil, operate the engine for a short period and check that there
is no oil leakage. Stop the engine when completed.
(3) Cleaning/Replacing the Air Element
Cleaning 1st time: 50th hour 2nd time and after: Every 100 hours
Replacement Every 400 hours
1) Release the air cleaner clips and remove
the cleaner cap.
2) Clean or replace the air element.
＜
If dry dust is adhering
＞
Spray compressed air from within the
element.
＜
If carbon or oily substance is adhering
＞
Replace with a new part.
3) Install in the reverse order of removal.
<<<<
Note
>>>>
•
Clean sooner than scheduled if using the
equipment in a dusty location.
•
Element part no.: 1G319-11211(Kubota part no.)
(4) Cleaning/Replacing the Fuel Strainer
Cleaning 1st time: 50th hour 2nd time and after: Every 100 hours
Replacement Every 400 hours
1) Turn the fuel lever to "CLOSE".
2) Turn the retainer ring to the left
and remove the cup and element.
3) Remove any water or foreign
material from the cup and clean the
element using compressed air.
（
Or replace the element.
）
4) Install in the reverse order of removal.
<<<<
Note
>>>>
•
Check that no foreign material is adhering to the packing then install the cup.
•
After installation, turn the fuel lever to "OPEN" and check that there is no fuel
leakage. After checking, turn the fuel lever to "CLOSE" .
•
Element part no.: 16271-43561 (Kubota part no.)
Clip
Clip
Air Cleaner
Element
Air Cleaner Cap
Clip
Retainer
Ring
Element
Close
Open
Fuel
Lever