Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 34 / 48

- 31 -
Warning: Fire
•
Always be sure to stop the engine when inspecting fuel or refueling, and
absolutely never perform such tasks near fire or other open flame. Wait
until the engine has completely cooled before inspecting fuel or refueling.
•
Always be sure to wipe up any spilled fuel or oil.
•
Spilled fuel and oil accumulates in the spill containment. Do not operate
the equipment with liquid accumulated in the spill containment.
•
Absolutely never use the equipment if there is a fuel, oil or cooling water
leak, and be sure to always repair the leak before using.
•
Absolutely never inspect or perform maintenance to the equipment near
fire or other open flame.
Warning: Injury to Eyes and Skin
•
Use protective gear, such as rubber gloves, when inspecting or replacing
the battery due to the dilute sulfuric acid in the battery fluid. Be sure that
fluid does not get into eyes, or on skin or clothing.
•
If battery fluid gets into the eyes, or on the skin or clothing, immediately
wash with a large amount of water, and always be especially sure to
seek medical attention if it gets into the eyes.
Warning: Explosion
•
Do not operate the equipment or recharge the battery when the battery
fluid level is below the lower level.
•
Do not generate any sparks near the battery and do not allow any fire or
other open flame near the equipment because the battery generates
ignitable gas.
Caution: Burn
•
The engine, muffler and similar parts are extremely hot during operation
and immediately after stopping the equipment. Never touch hot parts.
•
Never open the radiator cap during operation or immediately after
stopping the equipment. Hot cooling water and steam will spurt out.
•
Always be sure to stop the engine and allow it to cool before inspecting
or changing the engine oil. Opening the oil gauge or oil plug during
operation will result in hot oil spurting out.
<<<<
Note
>>>>
•
Procedures except for pre-operation inspection must be performed by specialized
technicians.
•
Items indicated by : Contact the retail outlet where the equipment was purchased.
•
Always be sure to use genuine parts when replacing parts.
•
When removing waste liquid from the equipment, place some container to collect
the liquid and prevent it from spilling on the ground. Dispose of such oil, fuel,
cooling water (LLC), filters, batteries and other harmful substances as industrial
waste in accordance with applicable laws and regulations. Consult with the retail
outlet where the equipment was purchased if you have any inquiries regarding
proper disposal.
•
When performing maintenance with doors or covers open, be sure that no other
persons can accidentally come close to the equipment. Close all doors and covers
if momentarily leaving the equipment unattended.