Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 14 / 48

- 11 -
<<<<
Note
>>>>
•
The VRD is only for weld output. It does not function for AC generated output
voltage.
5-3
． ． ． ．
Idle Control
The equipment includes an idle control function. You can use the idle control switch
to select an engine speed setting of "ECO" , "AUTO" or "HIGH" .
(1) Eco Drive
The equipment includes an eco drive function in order to reduce noise, save fuel,
and reduce exhaust gas emission.
When the idle control switch is set to "ECO" and only welding is being performed,
the engine operates at an optimal speed corresponding to the weld output and it
automatically returns to low speed when welding is stopped.
The eco lamp lights up during eco drive to indicate that operation is
environmentally considerate.
<<<<
Note
>>>>
•
The engine speed optimization function of eco drive is only for welding.
•
If using as an AC power source during eco drive (including when welding and
using as an AC power source at the same time), the engine operates at high
speed and the eco lamp turns off.
•
Set the idle control switch to "AUTO" or "HIGH" if welding or using as an AC
power source in an intermittent manner.
•
Set the idle control switch to "HIGH" if using a high capacity motor, precision
instruments or AC load with an attached magnetic switch.
•
Set the idle control switch to "HIGH" if using as an AC power source of a device of
1 A or less because the engine might not reach a high speed as speed control
does not operate at that level.
(2) Auto Idle
The equipment includes an auto idle function in order to reduce noise, save fuel,
and reduce exhaust gas emission.
You can set the idle control switch to "AUTO" so that the engine operates at low
speed when not welding or using the equipment as a power source.
When you start to weld or use as an AC power source, the engine automatically
increases to high speed. When in a no-load condition, the engine automatically
returns to low speed after approximately 8 seconds of high-speed operation.
<<<<
Note
>>>>
•
Set the idle control switch to "HIGH" if using a high capacity motor, precision
instruments or AC load with an attached magnetic switch.
ECO Lamp
Idle Control Switch