Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 36 / 48

- 33 -
Inspection Period
Inspection Item
Pre-
Operation
Inspection
50th
hour
Every
100
hours
Every
200
hours
Every
400
hours
Every
1,000
hours Every
2,000
hours
20
Adjust/Lap Clearance of
Air Intake/Release
Valves
●
Adjust-
ment
●
Lapping
21
Inspect/Adjust Clearance
of Fuel Injection Valves
●
22
Inspect/Adjust Fuel
Injection Pump
●
23
Clean/Inspect Spill
Containment
●
Or
1years
(1) Changing the Engine Oil
1st time 50th hour
2nd time
and after
Every 100 hours
1) Remove the oil plug.
2) Remove the oil drain plug and
drain the engine oil.
3) Tighten the oil drain plug.
4) Add oil through the oil inlet,
while checking the oil level using
the oil gauge, until it reaches the
maximum level. (Fill with approx.
3.6 L.)
5) Tighten the oil plug.
<<<<
Note
>>>>
•
Refer to section "6-1. Engine Oil Inspection" for the types of engine oil.
•
Replace the packing of the oil drain plug with a new part each time the oil is
changed.
•
Packing part no.: 6C090-58961 (Kubota part no.)
•
After tightening the oil drain plug, operate the engine for a short period and check
that there is no oil leakage. Stop the engine when completed.
(2) Changing the Oil Filter
1st time 50th hour
2nd time
and after
Every 200 hours
1) Drain the engine oil according to
the procedures of " (1) Changing
the Engine Oil".
2) Remove the oil filter using a filter
wrench.
3) Apply a thin layer of oil to the gasket of a
new oil filter.
Oil Plug
Oil Inlet
Oil Filter
Gasket
Oil Drain Plug
Oil Gauge