Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 15 / 48

- 12 -
•
Set the idle control switch to "HIGH" if using as an AC power source of a device of
1 A or less because the engine might not reach a high speed as speed control
does not operate at that level.
(3) High Idle
You can set the idle control switch to "HIGH" to maintain the engine constantly at
high speed.
5-4
．
． ．
．
Weld Mode Selector
You can select a weld mode of "DROOP-STANDARD
／
GOUGING" ,
"CC-CELLULOSE
／
SCRATCH START TIG" in accordance with the type of welding
being performed.
■
DROOP(Drooping Characteristic)-STANDARD
／
GOUGING
The weld current can be adjusted by
manipulating the welding rod due to being able
to increase or decrease the current for changing
the arc length, thereby allowing you to adjust the
arc status and weld beads.
The arc start is good and the arc is strongly felt.
This mode is optimal for welding work such as
pipe welding or when using special welding
rods.
■
CC(Constant Current)-CELLULOSE
／
SCRATCH START TIG
Welding can be performed at a constant uniform current even if the arc length
changes due to a shaky hand or similar cause to provide a stable arc that is not
easily extinguished.
Welding can be performed at a specified current value without being affected by
the length or thickness (thinness) of the welding cable. This mode is optimal for
general welding as the stable arc reduces the amount of spatter.
5-5
． ． ． ．
Remote Control
（ （ （ （
Option
） ） ） ）
You can connect the remote controller to the remote control connector to enable
remote operation of weld current adjustment.
1) Remove the remote control cover from the operation panel.
（
2-M4 screws
）
2) Connect the plug of the extension cord (cord reel) into one of the dedicated
remote control connector (side A or B).
3) Connect the plug of the remote controller into the receptacle of the extension
cord (cord reel).
Up to 3 cord reels (30 m x 3) can be connected.
Weld Mode Selector
Remote Controller
Caution
Lamp
Remote Control Connector