Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 30 / 48

- 27 -
<<<<
Note
>>>>
•
This equipment allows for 2 person simultaneous welding. For 2 person
simultaneous welding, select a weld mode and adjust the weld current in
accordance with each type of welding work being performed.
•
The range of weld current that can be adjusted using the output control dial varies
depending on the positions of the single/dual selector and frequency selector.
(Refer to section "2
．
Specifications" .)
1) Switch the single/dual selector and frequency selector in accordance with the
amount of welding personnel and desired weld output.
2) Switch the weld mode selector in accordance with the work being performed.
3) Adjust the output current using the output control dial.
The set current that has been pre-set using the output control dial is
displayed by the DC meter when not welding.
（
"PRESET" lamp lights up
）
During welding, the DC meter display the actual output current.
（
"ACTUAL"
lamp lights up
）
9-1
． ． ． ．
Output Types and Ranges
(1)3-Phase
The equipment includes one 3-phase
receptacle.
The maximum output available from the
receptacle is 400V-12kVA at 50Hz.
The maximum output available from the
receptacle is 440V-15kVA at 60Hz.
(2)1-Phase
The equipment includes three 1-phase receptacles.
The total maximum output available from the three receptacles is 230V-9.6kVA at
50Hz.
The total maximum output available from the three receptacles is 250V-11.3kVA at
60Hz.
9. Using as a Generator
Preset Lamp
Actual Lamp
Single/Dual
Selector
DC Meter
Output Control Dia
l
Preset Lamp
Actual Lamp
Weld Mode
Selector Weld Mode
Selector
1-P
Receptacle
3-P Receptacle