Shindaiwa DGW400DM-C, Руководство владельца и оператора

Страница: 38 / 48

- 35 -
(5) Draining Water from the Fuel Tank
Draining
Water
Every 200 hours
1) Remove the fuel drain plug.
2) Drain the water and tighten the fuel
drain plug.
<<<<
Note
>>>>
•
Replace the packing with a new part each time you drain the water.
•
Packing part no.: 6C090-58961 (Kubota part no.)
•
Always be sure to check that there is no fuel leakage after tightening the fuel drain
plug.
(6) Changing the Cooling Water
Change Every 2,000 hours or 2 years
Cooling Water Total Capacity: Approximately 4 L
(Including the sub tank capacity of approx. 0.6 L)
1) Open the top plate.
2) Remove the radiator cap.
3) Remove the water drain plug.
4) Drain the cooling water and tighten
the water drain plug.
5) Change the cooling water in the sub tank.
6) Pour cooling water into the water inlet until
it reaches the mouth of the port.
7) Tighten the radiator cap.
8) Close the top plate.
<<<<
Note
>>>>
•
Replace the packing with a new part each
time you change the cooling water.
•
Packing part no.: 6C090-58961 (Kubota
part no.)
•
Operate the engine for a short period and check that there is no cooling water
leakage. Stop the engine when completed.
(7) Draining Liquid from the Spill Containment
Drain Pre-operation
1) Set a receptacle under the drain port of the spill containment to catch the
liquid.
2) Remove the plug (R 1/2") of the spill containment drain valve and turn the
lever to "OPEN".
3) After draining the liquid, turn the lever to "CLOSE", and apply sealing agent
to the plug (R 1/2") or wrap it with sealing tape before tightening the plug.
Fuel Drain Plug
Radiator Cap
Water
Inlet
Top Plate
Water Drain Plug
Sub
Tank