Shibaura ST318, Руководство по ремонту

Страница: 71 / 247

70
5) ASSEMBLY
Assembly is the reverse of the disassembly procedure.
Be care ful of the following points.
(1) Brush
When a new brush is installed, it should protrude from
brush holder by 1.5 mm.
(2) Rotor
Before the rotor is installed, the brush should be
pushed into the brush holder. (See Figure T192). The
rotor cannot be placed in position unless the brush is
pushed in. Failure to insert the brush will lead to its
becoming damaged.
T192
Brush Installation
T193
Brush Supporting
6) MEASUREMENT ON VEHICLE
(1) Regulated voltage check (IC regulator)
1. Connect the voltmeter and ammeter in the manner shown in Figure T194, and turn on the ignition switch. Check that
the charge lamp is turned on.
2. Check if charge lamp is turned off when the engine starts.
3. Maintain an engine speed of 2000 rpm, and check battery voltage with an output current of 10A. (Check for regulator
voltage)
Example:Standard 14.2 V to 14.8 V (A type IC regulator)
Caution : The standard temperature for an IC regulator is 25°C and, therefore, the voltage reading should be taken
quickly. The maintenance standard for each type, therefore, should be followed.
T194
Check of Regulator Voltage