Shibaura ST318, Руководство по ремонту

Страница: 108 / 247

107
3. WHEEL
ALIGNMENT
Inspection and service
1. Toe-in
When the steering link system is disassembled,
perform the wheel alignment by adjusting the length of
the tie rod.
Standard value (A – B) -5 ~ +5 mm
(Inclination angle of king pin, caster and camber fixed)
2. Swing angle
(1) Check for the dimension from the wheel shaft case
and bolt end surface to be as follows;
Bolt length Swing angle
29±1mm 4°30'
(2) If stopper bolt top surface has worn out unevenly,
replace the bolt.
T427
T428
4. FRONT WHEEL
1) Specifications
ST318 ST321·ST324
Tire size Rim size Tire size Rim size
Agriculture 5 – 12 3.00D – 12 6 – 12 4JA × 12WDC
Turf 20 × 8.00 – 10 6.00I × 10 20 × 8.00 – 10 6.00I × 10
2) Inspection of Tire
Tire size 5 – 12 6 – 12 20 × 8.00 - 10
1. Wear of tire (mm)
· Lag height when new
· Lag height in service
limit
25
14 28
14 7
4
2. Tightening Torque of Disk
N·m (kgf·m)
58.8 – 74.5 (6.0 – 7.6)
3. Rim run-out (mm) Service limits within 5
4. Air pressure of tire See Operator’s manual