Shibaura ST318, Руководство по ремонту

Страница: 160 / 247

159
(2) Link system
Check procedure
1. Adjustment of control rod and pedal stop
➀
Adjust the length of the control rod, from the
turnbuckle top end to the bottom rod end center, to
137 mm.
➁ Adjust the length from the top of the turnbuckle to
the bottom of the spring holder to 26 mm.
➂ Adjust the pedal forward side stop bolt by stepping
the pedal fully, turning the bolt by 1 turn form that
position (to lengthen), and lock with nut.
1. Pedal stop bolt
2. Adjustment of HST neutral
➀ Raise the tractor rear and front axles so the rear and
front wheels are off the ground and place safety
stands under the axles.
Start the engine and place the HST pedal, A, in the
NEUTRAL position. The rear wheels should not
rotate in either direction.
➁ For fine adjustments of the NEUTRAL position,
loosen lock nuts, B and C and turn the turnbuckle,
D, 1/4 turn at a time, clockwise for reverse wheel
rotation or counter clockwise for forward wheel
rotation, until the rear wheels are at a complete
stop.
NOTE: This procedure is based on the assumption
that the HST spring housing and HST
linkage has been pre-set at 163mm.
T585
T586