Shibaura ST318, Руководство по ремонту

Страница: 156 / 247

155
Reassembly
Reassembly units in the reverse order to disassembly
taking care of the following points.
After completion of reassembly, rotate the input, output,
and trunnion shafts respectively to check for smooth
operation.
1. Tightening torque at each part
Part
Tightening torque
N · m (kgf · m)
➀
Holder
➁
Charge pump case
➂ Pump case
➃ Motor case
➄
Motor case cover
➅ Pressure detection plug
➆ High pressure relief valve
➇
Check valve
35.3 – 43.1 (3.6 – 4.4)
15.9 – 19.5 (1.6 – 2.0)
35.2 – 43.2 (3.6 – 4.4)
35.2 – 43.2 (3.6 – 4.4)
7.1 – 8.7 (0.72 – 0.88)
48.5 – 59.3 (4.9 – 6.0)
33.1 – 40.5 (3.4 – 4.1)
33.1 – 40.5 (3.4 – 4.1)
2. Install the right and left covers to the pump case taking
care to the bush joining position in the cover.
NOTE: The bush joining direction to against the
port block when installing.
Tightening torque
2.0 – 2.6 N
·
m
(0.20 – 0.26 kgf · m)
3. Install assembling jigs to the subassembled cylinder
block (with washer, spring and snap ring installed), and
install 3 pins to the cylinder block spline groove.
Then install the retainer holder, retainer plate, and
piston sub-assembly.
(Reassemble motor cylinder block in the same way.)
1. Pin
2. Assembling jig
T571
T572
T573
T574