Shibaura ST318, Руководство по ремонту

Страница: 213 / 247

212
2. Control lever return rod adjustment
➀
Install the lever return rod with spring and three
washers to the bracket, and tighten the lock nuts at
one or two screw threads shown.
➁ Move the position control lever to the position: Ⓐ .
➂ Slide the bracket and return rod assembly to contact
the return rod and plate on the position control lever,
and then tighten the two bolts, Figure T685.
3. Adjustment of feedback link
➀
Start the engine (800 – 1000 rpm), and set the
control lever at the position
Ⓐ
, figure T686.
(Confirm that the lift arm rises to the uppermost
point.)
➁
Untighten the lock nut and drive in the nut
rearwards.
Then the lift arm rises. The lift arm lowers when the
nut is untightened. Tighten the nut at the point
where the relief is effected, return (untighten) the
nut by 1.5 turns from that position, and fix with the
lock nut.
➂ After adjustment, confirm that the relief is not
effected operating the control lever at the position
(A), Figure T686 and it is returned position by
return rod.
T685
T686
T687
T688