AR-BC260 SETTING AND ADJUSTMENTS 8 - 23
(2) Copy color balance/density adjustment procedure flow
Follow the flowchart to perform the copy color balance/density adjustment.
START
Perform ADJ 11A
CCD gamma adjustment.
SIM 63-3 (Normal document mode)
Check the copy color balance/density adjustment.
(Manual operation) Text/Printed photo mode
(Test chart UKOG-0162FCZZ/UKOG-0283FCZZ is used.)
Are the copy
color balance and density
at satisfactory
levels?
YES
NO
(Next page)
(Next page)
Is the CCD replaced?
YES
NO
Set the SIT chart
(UKOG-0280FCZZ) on
the original table.
Enter the SIM 63-03
mode and press the
EXECUTE key.
Check the copy color balance/density adjustment.
(Manual operation) Text/Printed photo mode
(Test chart UKOG-0162FCZZ/UKOG-0283FCZZ is used.)
Process correction is forcibly
performed. (SIM 44-6)
Execute the half tone image
correction. (SIM 44-26)
The necessary work items for each condition are marked with "
∗
."
When replacing a consumable part, /when repairing or checking
(without replacement of a consumable part) /
when installing the machine, follow the workflow below.
: Standard adjustment flow
When servicing (When a consumable part is replaced)/maintenance
JOB No
Work item
Simulation
When
installing
After replacing
OPC drum
After replacement
of the image
density sensor
After replacing
transfer belt
After cleaning
scanner
(reading) section
When in
periodic
maintenance
When in
repair/check
(without replacing
consumable parts)
ADJ 2
Image density sensor adjustment
OPC drum counter clear
Transfer section waste toner counter clear
Set the half tone correction level to zero. (Reset)
∗
∗
∗
∗
∗
∗
∗
24-7
24-8
∗
∗
∗
∗
44-27
∗
ADJ 3
ADJ 4
Image focus, image skew adjustment
(LED (writing) unit)
Image registration adjustment
64-1/61-4
50-22/50-20
1 '
44-2/44-13