SEW-Eurodrive MOVIGEAR DAC B, Руководство по эксплуатации

Страница: 94 / 258

94
Operating Instructions – MOVIGEAR® DAC-B
6
Startup with double slave GLK31A
Startup
6.7 Startup with double slave GLK31A
6.7.1 Startup procedure
1. It is essential that you observe the startup instructions.
2. Disconnect all components from the voltage supply and use an external disconnect-
ing device to avoid an unintentional re-connection.
3. Set DIP switch S1/1 to ON to activate "Expert" mode.
4. Make sure that the MOVIGEAR
®
drive unit is connected properly. Observe chapter
"Electrical Installation".
5. Place the MOVIGEAR
®
electronics cover onto the connection box and screw it on.
6. Switch on the following voltages.
• AS-Interface voltage
• Supply voltage
7. Set the desired AS-Interface address.
• With a hand-held programming device
• With an AS-Interface master (see description master)
INFORMATION
• Startup with the GLK31A double slave only makes sense in "Expert" mode.
• The following chapter describes the preparations made on MOVIGEAR
®
for
activating the Expert mode and an example for fine-tuning parameters.
• The chapter "Parameterization and diagnostics" describes how you integrate
MOVIGEAR
®
in MotionStudio and contains an overview of all parameters with a
detailed description.
• For detailed information about the function of the double slave, refer to chapter
"Communication with AS-Interface double slave GLK31A".
2444784139
ON DIP
1 2 3 4
S2
DIP switch S2/1 = ON
Expert mode
NOTICE
Set the DIP switches using suitable tools, e.g. a slotted screwdriver with a blade width
< 3 mm.
The force used for setting the DIP switches must not exceed 5 N.
0 0
I