SEW-Eurodrive MOVIGEAR DAC B, Руководство по эксплуатации

Страница: 83 / 258

Operating Instructions – MOVIGEAR® DAC-B
83
6
Description of the DIP switches
Startup
6.3.2 Description of the DIP switches
DIP switch S1/1 Setting the maximum PWM frequency
• When DIP switch S1/1 is set to "OFF", MOVIGEAR
®
operates with a PWM frequency
of 4 kHz.
• When DIP switch S1/1 is set to "ON", the MOVIGEAR
®
unit operates with a 16 kHz
PWM frequency (low noise) and switches back to 4 kHz depending on the heat sink
temperature and unit utilization.
DIP switch S1/2 Releasing DynaStop
®
without enable
When switch S2/2 is set to "ON", it is possible to deactivate DynaStop
®
even without
drive enable signal.
DIP switch S2/1 Startup mode setting
You can select one of the following modes for starting up MOVIGEAR
®
:
• When selecting "Easy" (DIP switch S2/1 = "OFF"), you can start up MOVIGEAR
®
using DIP switches S1, S2 and switches f2, t1 quickly and easily.
• In "Expert" mode (DIP switch S2/1 = "ON"), an extended range of parameters is
available. You can use the MOVITOOLS
®
MotionStudio software to adjust the
parameters to the application.
DIP switch S2/3 Direction of rotation reversal
You can reverse the direction of rotation of the drive via this DIP switch.
• OFF (S2/3 = OFF): The motor turns CW for a positive setpoint and CCW for a
negative setpoint.
• ON (S2/3 = ON): The motor turns CCW for a positive setpoint and CW for a negative
setpoint.
DIP switch S2/4 Speed monitoring (only active in "Easy" mode)
• Speed monitoring (S2/4 = "ON") protects the drive when it is blocked.
• If the drive is operated at the current limit for longer than 1 second when speed
monitoring is active (S2/4 = "ON"), then speed monitoring is tripped. MOVIGEAR
®
indicates an error via the status LED. The current limit must be reached permanently
for the duration of the delay time before monitoring responds.
INFORMATION
For more information about deactivating DynaStop
®
without drive enable, refer to
chapter "Operation".
0 0
I