SEW-Eurodrive MOVIGEAR DAC B, Руководство по эксплуатации

Страница: 126 / 258

126
Operating Instructions – MOVIGEAR® DAC-B
8
Description of command pcb parameters
Parameters
8.3.2 Setpoints/ramp generators
Command pcb parameters \ setpoints/ramp generators \ setpoint selection
Disabling
mechanical control
elements
index 10096.30
bits 13 – 15
Use this bit-coded selection box to disable the mechanical controls of the MOVIGEAR
®
inverter.
The value of the parameter set at the factory enables all mechanical controls.
Command pcb parameters \ setpoints/ramp generators \ speed ramps
Ramp t11 up
index 8807.0
Use this parameter to set acceleration ramp "t11 up".
• Unit: [s]
• Setting range: 0 – 1 – 60 s
The ramp times refer to a setpoint step change of ∆ n = 3000 rpm.
In conjunction with AS-Interface double slave GLK31A, the parameter is used to set the
acceleration ramp for function modules 1, 5, 7 of the double slave.
Ramp t11 down
index 8808.0 Use this parameter to set deceleration ramp "t11 down".
• Unit: [s]
• Setting range: 0 – 1 – 60 s
The ramp times refer to a setpoint step change of ∆ n = 3000 rpm.
In conjunction with AS-Interface double slave GLK31A, the parameter is used to set the
deceleration ramp for function modules 1, 5, 7 of the double slave.
Stop ramp t13
index 8476.0 Use this parameter to set stop ramp "t13".
• Unit: [s]
• Setting range: 0 – 0.2 – 60 s
The stop ramp is active in the event of a voltage drop or a fault (parameterizable fault
responses).
Bit Meaning Note
13 Deactivating the setpoint potenti-
ometer f1 Bit not set: Setpoint potentiometer f1 active
Bit set: Setpoint potentiometer f1 not active
Setting the setpoint and the maximum
speed using parameters
14 Deactivating switch f2 Bit not set: Switch f2 active
Bit set: Switch f2 not active
Setting the setpoint and the minimum
speed using parameters
15 Deactivating switch t1 Bit not set: Switch t1 active
Bit set: Switch t1 not active
Setting the ramp times using parameters
0 0
I