Seneca S6001, Руководство пользователя

Страница: 102 / 122

Doc. MI004620-I
S6001 Pump controller
Rev. 0
www.seneca.it
102 / 122
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION CAN
BE REPRODUCED WITHOUT PREVIOUS AUTHORIZATION.
User Manual
Code
Alarm
Description Cause Solution
OT041 UPS FLAT BATTERY ALARM
A “UPS FLAT BATTERY” signal
has been configured among the
configurable digital inputs and
the contact connected to this
input is closed.
- Check the configuration of
the digital inputs in the SET -
TINGS > IO DIGITAL TYPE
section of the HMI panel is
correct. Check the wiring of the
auxiliary contacts of the “UPS
FLAT BATTERY” signal is cor -
rect.
OT043
PUMP 1 ANALOGUE PROBE
FAULT (A)
A “PUMP 1 ABSORPTION” sig -
nal has been configured among
the configurable analogue in -
puts, but the probe is not con -
nected or is not working prop -
erly.
- Check the configuration of the
digital inputs in the SETTINGS
> IO ANALOGUE TYPE sec-
tion of the HMI panel is correct.
Check the wiring of the probe is
correct - Check the polarity of
the probe signal.
OT044
PUMP 2 ANALOGUE PROBE
FAULT (A)
A “PUMP 2 ABSORPTION” sig -
nal has been configured among
the configurable analogue in -
puts, but the probe is not con -
nected or is not working prop -
erly.
- Check the configuration of the
digital inputs in the SETTINGS
> IO ANALOGUE TYPE sec-
tion of the HMI panel is correct.
Check the wiring of the probe is
correct - Check the polarity of
the probe signal.
OT045
PUMP 3 ANALOGUE PROBE
FAULT (A)
A “PUMP 3 ABSORPTION” sig -
nal has been configured among
the configurable analogue in -
puts, but the probe is not con -
nected or is not working prop -
erly.
- Check the configuration of the
digital inputs in the SETTINGS
> IO ANALOGUE TYPE sec-
tion of the HMI panel is correct.
Check the wiring of the probe is
correct - Check the polarity of
the probe signal.
OT046
PUMP 4 ANALOGUE PROBE
FAULT (A)
A “PUMP 4 ABSORPTION” sig -
nal has been configured among
the configurable analogue in -
puts, but the probe is not con -
nected or is not working prop -
erly.
- Check the configuration of the
digital inputs in the SETTINGS
> IO ANALOGUE TYPE sec-
tion of the HMI panel is correct.
Check the wiring of the probe is
correct - Check the polarity of
the probe signal.