Doc. MI004620-I
S6001 Pump controller
Rev. 0
www.seneca.it
25 /
122
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION CAN
BE REPRODUCED WITHOUT PREVIOUS AUTHORIZATION.
User Manual
1.12.2.1
HMI assembly instructions
It is forbidden
to mount the HMI in environments exposed to direct sunlight in order not to
accelerate the ageing process of the frontal film.
To mount the HMI, carry out the following operations in the given order:
1.
prepare a cut-out hole of the dimensions indicated in
“1.9.1.2 HMI mechanical technical
characteristics” on page 17
;
8.
insert the HMI in the cut-out hole;
The maximum deviation between the surface of the cut-out hole and the HMI must be 0.5 mm.
9.
insert the 4 fixing screws in the appropriate seats as indicated in
Fig. 8 on page 25
;
10.
tighten the screws.
Fig. 8 HMI assembly
1.1
ELECTRICAL CONNECTIONS
1.1.1 Warnings on electrical connections
Verify that all electrical connections are properly made and that there is a
ground connection before powering the product.
It is compulsory to use appropriate voltage detection devices to confirm
the absence of power and insulated tools, before making any electrical
connections.
For electrical connections follow the following instructions:
Содержание S6001
Страница 1: ...ORIGINAL INSTRUCTIONS USER MANUAL S6001 Pump controller...
Страница 2: ......
