SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 349 / 399

6AL3J11
8-38
1
2
3
4
5
6
7
8
9
NOTE:
• Before checking the water detection switch,
make sure that the float
4
is able to move
to positions
È
and
É
as shown.
• Be sure not to remove the clip
3
and float
4
, otherwise the water detection switch
may be damaged.
8. Install the fuel filter cup assembly and
connect the water direction switch cau-
pler (blue).
NOTE:
Do not twist the water detection switch lead
when installing the fuel filter cup assembly.
Checking the fuel injector
1. Check the operation of the fuel injectors
using the
“ Stationary test ” of the YDIS
and listen for the operating sound.
2. Disconnect the fuel injector couplers.
3. Turn the engine start switch to “ ON, ” and
then measure the input voltage between
the fuel injector coupler terminal and
ground. Check the wiring harness if
below specification.
4. Turn the engine start switch to “ OFF. ”
5. Measure the fuel injector resistance.
6. Connect the fuel injector couplers.
Float height:
Water detection position
a
:
30 mm (1.18 in)
Float
position
Lead color
Black (B) Black (B)
È
É
S6AL8771
B B
3
4
È
S6AL8781
B B
É
4
3
a
Fuel injector input voltage:
Red/yellow (R/Y) – Ground
12 V (battery voltage)
Fuel injector resistance
(reference data):
12.0
Ω
at 21 ° C (70 ° F)
R/Y
S6AL8600
STBD
S6AL8610
Variable camshaft timing control system / Fuel control system