SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 28 / 399

GEN
INFO
General information
1-23
6AL3J11
Checking the outboard motor
mounting height
1. Check that the anti-cavitation plate is
aligned with the bottom of the boat. If the
mounting height is too high, cavitation
will occur and propulsion will be reduced.
Also, the engine speed will increase
abnormally and cause the engine to
overheat. If the mounting height is too
low, water resistance will increase and
reduce engine efficiency.
NOTE:
The optimum mounting height is affected by
the combination of the boat and the outboard
motor. To determine the optimum mounting
height, test run the outboard motor at differ-
ent heights.
2. Check that the clamp brackets are
secured with the clamp bolts.
Checking the remote control cable
1. Set the remote control lever to the neu-
tral position and fully close the throttle
lever.
2. Check that the accelerator lever
1
con-
tacts the fully closed stopper
2
.
NOTE:
To adjust the throttle cable, see Chapter 3,
“ Adjusting the throttle cable. ”
3. Check that the center of the set pin
a
is
aligned with the alignment mark
b
on
the bracket.
WARNING
The shift/throttle cable joint must be
screwed in a minimum of 8.0 mm (0.31 in)
c
.
2
1
S6P21030
S6AL3120
c