SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 304 / 399

BRKT
Bracket unit
7-55
6AL3J11
3. Remove all of the air bubbles with a
syringe or suitable tool.
NOTE:
Turn the joint
1
with a screwdriver, and then
remove any air between the pump gear teeth.
4. Install a new O-ring
2
and the PTT
motor
3
, and then tighten the bolts
4
to
the specified torque.
NOTE:
Align the armature shaft with the recess in
the joint.
Installing the reservoir
CAUTION:
Do not use a rag when assembling the
PTT unit as dust and particles on the PTT
unit components can lead to poor perfor-
mance.
1. Install the spacer
1
, filter
2
and sheet
3
to the PTT body.
2. Install a new O-ring
4
and the reservoir
5
, and then tighten the bolts
6
to the
specified torque.
3. Install a new O-ring and the reservoir cap
7
, and then tighten the reservoir cap to
the specified torque.
Installing the tilt ram
CAUTION:
Do not use a rag when assembling the
PTT unit as dust and particles on the PTT
unit components can lead to poor perfor-
mance.
1. Place the tilt cylinder end screw at the
position
a
(bottom of the tilt ram).
2. Fill the tilt cylinder with the recommended
fluid to the correct level
b
as shown.
3. Add a small amount of the recommended
fluid through the PTT body hole
c
as
shown.
T
R
.
.
PTT motor mounting bolt
4
:
19 N · m (1.9 kgf · m, 14.0 ft · lb)
T
R
.
.
Reservoir mounting bolt
6
:
19 N · m (1.9 kgf · m, 14.0 ft · lb)
Reservoir cap
7
:
7 N · m (0.7 kgf · m, 5.2 ft · lb)
Recommended PTT fluid:
ATF Dexron
II