SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 63 / 399

6AL3J11
3-14
1
2
3
4
5
6
7
8
9
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PTT unit should lose
fluid pressure.
2. Remove the reservoir cap
2
, and then
check the fluid level in the reservoir.
WARNING
Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the reservoir cap is removed.
3. If necessary, add sufficient fluid of the
recommended type until it overflows out
of the filler hole.
4. Install a new O-ring and the reservoir cap
2
, and then tighten the reservoir cap to
the specified torque.
Lower unit
3
Checking the gear oil level
1. Fully tilt the outboard motor down.
2. Remove the gear oil check screw
1
, and
then check the gear oil level in the lower
case.
NOTE:
If the oil is at the correct level, a small
amount of oil should overflow out of the
check hole when the gear oil check screw is
removed.
3. If necessary, add sufficient gear oil of the
recommended type until it overflows out
of the check hole.
4. Install a new gasket and the gear oil
check screw
1
, and then tighten the
gear oil check screw to the specified
torque.
Changing the gear oil
1. Tilt the outboard motor up slightly.
Recommended PTT fluid:
ATF Dexron
II
T
R
.
.
Reservoir cap
2
:
7 N · m (0.7 kgf · m, 5.2 ft · lb)
Recommended gear oil:
Hypoid gear oil
API: GL-4
SAE: 90
T
R
.
.
Gear oil check screw
1
:
9 N · m (0.9 kgf · m, 6.6 ft · lb)
S60V3320
1
Control system / Bracket unit / Lower unit