SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 167 / 399

6AL3J11
5-66
1
2
3
4
5
6
7
8
9
NOTE:
Make sure that the marks
b
of the connect-
ing rod face toward the flywheel magnet end
of the crankshaft.
5. Tighten the connecting rod cap bolts to
the specified torques in 3 stages.
NOTE:
• Reuse the removed connecting rod cap
bolts when checking the oil clearance.
• Do not turn the connecting rod until the
crankpin oil clearance measurement has
been completed.
• In the 3rd stage, make a mark
c
on the
connecting rod cap bolts and connecting
rod caps, and then tighten the bolts 90
°
from the mark.
6. Remove the connecting rod cap and
measure the width of the compressed
Plastigauge (PG-1) on each crankpin.
Replace the connecting rod bearing if out
of specification.
Selecting the connecting rod bearing
1. When replacing the connecting rod bear-
ing, select the suitable bearing as fol-
lows.
T
R
.
.
Connecting rod cap bolt:
1st: 23 N · m (2.3 kgf · m, 17.0 ft · lb)
2nd: 43 N · m (4.3 kgf · m, 31.7 ft · lb)
3rd: 90 °
Crankpin oil clearance:
0.028 – 0.066 mm
(0.0011 – 0.0026 in)
Cylinder block