SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 283 / 399

6AL3J11
7-34
1
2
3
4
5
6
7
8
9
13. Remove the special service tool
2
.
WARNING
Make sure that the trim and tilt rams are
fully retracted when removing the special
service tool
2
, otherwise fluid can spurt
out from the unit due to internal pressure.
14. Install the pipe joint at the end
b
, and
then tighten the pipe joints
3
to the
specified torque.
15. After measuring the hydraulic pressure,
connect the PTT motor leads to the bat-
tery terminals to fully extend the trim and
tilt rams.
16. Place the PTT unit in an upright position.
17. Remove the reservoir cap
4
, and then
check the fluid level in the reservoir.
WARNING
Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the cap is removed.
18. If necessary, add sufficient fluid of the
recommended type to the correct level.
19. Install the reservoir cap
4
, and then
tighten it to the specified torque.
Ram PTT motor lead
Battery
terminal
Down
Light green (Lg)
+
Sky blue (Sb)
-
T
R
.
.
Pipe joint
3
:
15 N · m (1.5 kgf · m, 11.1 ft · lb)
T
R
.
.
Reservoir cap
4
:
7 N · m (0.7 kgf · m, 5.2 ft · lb)
PTT unit