SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 276 / 399

BRKT
Bracket unit
7-27
6AL3J11
Installing the PTT unit
1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever
1
.
WARNING
• When installing the PTT unit with the
power unit installed, be sure to suspend
the outboard motor. If the outboard
motor is not suspended it can fall sud-
denly and result in severe injury.
• After tilting the outboard motor up, be
sure to support it with the tilt stop lever.
2. Install the PTT unit mounting bolts
2
onto both clamp brackets together with
the PTT unit
3
, and then tighten them.
3. Install the upper end of the tilt ram into
the swivel bracket with the shaft
4
and
circlip
5
.
4. Tighten the self-locking nut
6
of the
through tube to the specified torque.
NOTE:
• Make sure that the flat corner
a
of the
through tube is pointing down as shown
before tightening the self-locking nut
6
.
• Do not pinch the trim sensor pin when
down the swivel bracket.
5. Install the anode
7
and ground lead.
6. Install the PTT motor lead to the holder
8
.
7. Pass the PTT motor lead and trim sensor
lead through the hole
b
in the starboard
clamp bracket.
8. Fasten the PTT motor lead and trim sen-
sor lead with the plastic ties
9
, and then
install the holder
0
.
9. Inject grease into all grease nipples until
grease comes out from the bushings
c
.
T
R
.
.
Self-locking nut
6
:
22 N · m (2.2 kgf · m, 16.2 ft · lb)
S6AL7590
9
b
9
9
9
;
STBD