SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 305 / 399

6AL3J11
7-56
1
2
3
4
5
6
7
8
9
4. Install the tilt piston assembly into the tilt
cylinder, and then tighten the tilt cylinder
end screw
1
to the specified torque.
NOTE:
Place the tilt cylinder end screw at the posi-
tion
a
and install the tilt piston assembly into
the tilt cylinder.
Bleeding the PTT unit
1. Place the PTT unit in an upright position.
2. Close the manual valve
1
by turning it
clockwise.
3. Remove the reservoir cap, and then
check the fluid level in the reservoir.
WARNING
Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole.
4. If fluid is below the correct level, add rec-
ommended fluid.
5. Install the reservoir cap, and then tighten
it to the specified torque.
Cylinder-end screw wrench:
90890-06568
T
R
.
.
Tilt cylinder end screw
1
:
90 N · m (9.0 kgf · m, 66.4 ft · lb)
S6AL7970
1
T
R
.
.
Manual valve
1
:
2 N · m (0.2 kgf · m, 1.5 ft · lb)
Recommended PTT fluid:
ATF Dexron
II
T
R
.
.
Reservoir cap:
7 N · m (0.7 kgf · m, 5.2 ft · lb)
Tilt cylinder and trim cylinder