SELVA MARINE Fin Whale 225 EFI, Руководство по обслуживанию

Страница: 333 / 399

6AL3J11
8-22
1
2
3
4
5
6
7
8
9
4. Remove the engine temperature sensor.
5. Place the engine temperature sensor in a
container of water and slowly heat the
water.
6. Measure the engine temperature sensor
resistance. Replace if out of specifica-
tion.
7. Install the engine temperature sensor,
and then connect the engine temperature
sensor coupler.
Checking the thermoswitch
1. Disconnect the thermoswitch connectors.
NOTE:
There are 2 thermoswitches: one on the port
side of the power unit and one on the star-
board side.
2. Turn the engine start switch to “ ON, ” and
then measure the input voltage at the
thermoswitch connectors (wiring harness
end). Check the wiring harness if below
specification.
3. Turn the engine start switch to “ OFF. ”
4. Remove the thermoswitches.
5. Place the thermoswitches in a container
of water and slowly heat the water.
Engine temperature sensor
resistance:
Black/yellow (B/Y) –
Black/yellow (B/Y)
at 20 ° C (68 ° F): 54.2 – 69.0 k
Ω
at 100 ° C (212 ° F): 3.12 – 3.48 k
Ω
S6AL8500
Thermoswitch input voltage:
Pink (P) – Black (B)
12 V (battery voltage)
S6AL8510
PORT
STBD
B
P
S6AL8520
P
B
Ignition and ignition control system