Rostock MAX v2 Assembly Guide – 4thEd.
Once you've got the two tabs on the top of the RAMBo mounting plate fitted into the two slots,
you can lift up and the mount will slide into place along the two support legs. The X, Y and Z stepper
motor wires can be routed directly under the board – there
is
room. Take care to not pinch a wire
between the bottom of the RAMBo mount and one of the support legs. The extruder stepper wire can
be routed to the right if you don't want to run it under the board.
17.10 – Installing the Power Switch and LCD Controller Cables
In the plastic box the LCD panel came in, you'll find two gray, flat ribbon cables and a small
circuit board marked “RAMBo to SmartController adapter”. These cables connect the LCD to the
RAMBo controller via the LCD interface board.
Label the adapter board's two 10 pin connectors as “A” and “B” as shown below.
Next, label the two cables with “A” on both ends
of one and “B” on both ends of the other.
Install the ribbon cables on the LCD interface board as shown.
Make sure that you've got the cables
inserted on to the headers
exactly
as shown –
you want the red line (pin 1) on each cable next
to the labels you wrote, just like it shows in
Fig. 17.10-3A (White PCB only)!
17 – Installing & Connecting the RAMBo Controller – 131
Fig. 17.10-1: Adapter labeled.
Fig. 17.10-2: Cables labeled.
Fig. 17.10-3A: "A" & “B” cables installed
(White PCB only!).
