89
Inside view
Important Care and Maintenance information
Every SeaLife housing is inspected for quality, including a 200ft (60m) pressure chamber test to
ensure a waterproof seal. It is your responsibility to properly care for housing and maintain the
O-ring sealing area. Carefully follow these important O-ring care instructions. Not following these care
instructions may cause the waterproof housing to leak and void your warranty.
• The underwater housing is depth tested to 200ft /60m. Exceeding this depth may cause the
housing to flood and may result in damaging the underwater housing and inner camera.
• Do not use any household cleaners, soaps, detergents or chemicals to clean the inner camera or
underwater housing. Chemicals may cause negative reaction with the plastic materials.
• Replace O-ring every year to ensure proper seal. Only use official SeaLife O-ring designed for the
DC2000 (Item # SL74017). Replacement O-rings are available at your local authorized SeaLife
dealer, or online at www.sealifepartsdirect.com (USA Only).
• Do not expose the inner camera or housing to direct sunlight for prolonged periods of time. Keep
camera and housing in shaded area or under a towel to prevent it from overheating.
• Do not disassemble or attempt to repair the camera or housing as this will void your warranty.
Contact your local authorized SeaLife dealer or the SeaLife Service Center in your country for
repairs.
• The camera and housing combination are positively buoyant by 14 grams. Attached included strap
to your wrist or buoyancy control device (BCD) when using the camera and housing in or near
water.
• Store camera and housing only after careful cleaning and when totally dry.
• Do not let any moisture or dirt get inside housing when opening. This may result in fogging when
using the camera underwater.
• Avoid opening housing in wet, sandy or humid environments. It is recommended to open and
load the housing in dry cool air, such as inside an air conditioned room. This will prevent water or
humidity from being trapped inside the housing, which may cause fogging during underwater use.
• Avoid getting sunscreen or suntan oil on the camera or housing, as it may cause discoloration of
the surface. If any oil gets on the camera or housing, clean it with moistened soft cloth.
• Store housing at room temperature in a clean and dry place.
17 – Moisture Muncher pocket.
Insert one SL911 Moisture
Muncher capsule here.
18 – O-ring contact surface.
Presses against the O-ring
when door is closed to form
waterproof seal.
19 – Silicone O-ring (Item
SL74017) seated into groove
