SEA SYSTEMS
INSTALLATION AND USE
STK3-GMV10 Control panel and Pre-wiring
For Hydraulic Elevators
MSTK3-GB
Rev.04
05/02/12
© Sea Systems S.r.l.
Page 33 of 81
C.3) Programmer Parameters and Use
The information relative to the configuration of the plant and its diagnostics is organized in
parameters which are identified in menus and submenus.
The programmer works in two separate modes:
•
Parameter Selection
The keys perform the operations to reach a specific parameter
•
Modify Parameter
The keys perform the operations needed to modify the value of the selected parameter
There are two types of parameters:
•
List Parameter
Parameters where the value can be selected from a set of possible values
•
Numerical Parameters
Parameters represented by a numerical value
Key Functions:
Modify Parameter
Symbol Parameter
Selection
List Numerical
ESC
Ö
Return the next higher level menu
Annul the change and return
to selection
Move the cursor one position
to the right
×
Page upwards through the menu
Shows the previous menu item
Shows the previous element Increases the numerical value
Ø
Page downwards through the
menu
Shows the next menu item
Shows the next element
Decreases the numerical
value
ENT
Activates the selected item:
If it is a menu, the menu is opened
If it is a parameter, it goes to the
mode for modification
Accept the selection made
and return to selection
End editing.
If the value inserted is not
valid, the cursor will be shown
again.
NOTE
For some parameters the keys perform special functions which are described in the
explanations for the specific parameters.
The
1. Diagnostics
menu parameters are only readable, with the exception of the
alarm reset parameter.
For safety reasons, the
2. Configuration
menu parameters can only be modified
with the FA valve disconnected; however they can be read at any time.
.
