Sea Tel ST14, Руководство по установке и обслуживанию

Страница: 49 / 84

ST14 Ku-Band TVRO Setup for Model ST14E
4-7
4.3.4.
Access all of the SATB individual parameters via a sub menu. If a second SAVED satellite is not needed,
preset SATB to “Empty” so when the
NEXT key is pressed the antenna will not search for any unwanted
satellite(s)
SATB - Second Satellite Parameters
All of the SATB parameters are set exactly the same way that the SATA parameters were set, but would be set
to different choices. Refer to the parameter setting information in the SATA – First Satellite Parameters
paragraphs to set PRESET, NAME, LON, Lo Band and Hi Band VERT freq’s, HORZ freq’s, BAUD’s, FEC’s, and
NID’s for the second satellite you wish to use periodically.
4.3.5.
Access all of the SATC individual parameters via a sub menu. If a third SAVED satellite is not needed, preset
SATC to “Empty” so when the
NEXT
key is pressed the antenna will not search for any unwanted satellite(s).
SATC - Third Satellite Parameters
All of the SATC parameters are set exactly the same way that the SATA parameters were set, but would be
set to different choices. Refer to the parameter setting information in the SATA – First Satellite Parameters
paragraphs to set PRESET, NAME, LON, Lo Band and Hi Band VERT freq’s, HORZ freq’s, BAUD’s, FEC’s, and
NID’s for the third satellite you wish to use periodically.
4.3.6.
Accessing the Factory Settings parameters should ONLY be done by a qualified technician from an
authorized Sea Tel dealer. The Model Serial Number can be found on the blue and silver label below the
reflector, on the blue frame of the pedestal. The parameters are:
FACTORY SETTINGS
4.3.6.1. Serial Number
This parameter sets Serial Number of the Antenna Pedestal into the PCU memory. The serial
number starts with 98 followed by 6 digits that are editable. This parameter allows the serial number
of the antenna to be displayed on the display of the Antenna Control Panel during the initialization
process.
NOTE: The Serial Number parameter setting is saved in the PCU, therefore,
MUST be set whenever the PCU is changed.
After this parameter has been set correctly, it must be SAVED in the PCU.
1. Press the
NEXT
key to select this sub-menu parameter for adjustment.
2. A cursor will appear under the rightmost digit. Press ▼ & ▲ arrow keys to
increment/decrement this digit.
3. Press the NEXT key to move the cursor to the digit to the left. Press
▼
&
▲
arrow keys to increment/decrement this digit.
4. Continue editing until all 6 digits have been set to the correct Serial Number of
the antenna pedestal that this PCU is mounted on. Press the
SAVE
key to save
the Serial Number parameter.
5. Press
SAVE
again to exit the sub-menu and return to the FACTORY SETTINGS
main menu display. From there you can press the
▲
arrow key to go UP through
the SAT numeric menu choices.
4.3.6.2. MODEL COASTAL ##
***The Model Configuration Sub-Menu is a
Read Only
parameter in this Version of Software.***
This parameter sets all of the internal drive, scale factor and limits for the motors, gear ratios and
sensors.
4.3.6.3. LAT (Ships Latitude)
This parameter is automatically set by the GPS antenna mounted on the Coastal pedestal inside the
radome. The GPS input enables the antenna to quickly & accurately target satellites (SATA – SATC)
when you press the NEXT key on the Antenna Control Panel.