Sea Tel ST14, Руководство по установке и обслуживанию

Страница: 31 / 84

ST14 Ku-Band TVRO Setup for Model ST14 D
2-11
4. Press the
NEXT
key to move the cursor to the next digit to the left. Press
▼
&
▲
arrow keys to increment/decrement this digit.
5. Press the
SAVE
key to save this parameter to memory.
2.3.11.6.3.
The HIGH LAT OFFS parameter defines what threshold offset value parameter is used when
the vessel is located within the Upper Latitude Range.
HIGH LAT OFFSET
1. Press the
NEXT
key to select this sub-menu parameter for adjustment.
2. A cursor will appear under the rightmost digit. Press
▼
&
▲
arrow keys to
increment/decrement this digit.
3. Press the NEXT key to move the cursor to the next digit to the left. Press ▼ & ▲
arrow keys to increment/decrement this digit.
4. Press the
NEXT
key to move the cursor to the next digit to the left. Press
▼
&
▲
arrow keys to increment/decrement this digit.
5. Press the
SAVE
key to save this parameter to memory
To operate the system in the mode previously known as Auto Threshold set all three
threshold offset parameters to the same value, thereby using the same Thresh Offset parameter
value regardless of the vessels Geo Location.
2.4. Saving the SETUP Parameters
When you have completed setting the desired parameters above, Press and Hold
SAVE
for 6 seconds to save the
changes you have made to the settings and exit SETUP Mode. “Settings Saved” will be displayed.
If you do NOT want to save the changes to NVRAM, Press
SAVE
+
▲
to exit SETUP Mode without permanently saving
any parameter changes.
NOTE:
You will save individual set-up parameter settings as you modify them in the procedure
below (quick presses of the
SAVE
key). These will only save the settings until POWER is cycled to
the antenna.
When you are finished making all of your desired changes, you
MUST press and hold the SAVE
key for three seconds
to write the changes you have made to memory (“Settings Saved” will be
displayed) in the PCU, so they will be available after POWER has been cycled to the antenna.