Sea Tel ST14, Руководство по установке и обслуживанию

Страница: 38 / 84

Setup for Model ST14M ST14 Ku-Band TVRO
3-6
paragraphs to set PRESET, NAME, LON, RHCP freq, BAUD, FEC, and NID for a third satellite that you wish to
use periodically.
3.3.7.
Access all of the SAT4 individual parameters via a sub menu. If a forth SAVED satellite is not needed, preset
SAT4 to empty/blank so
NEXT
will skip over this selection when you are switching satellites.
SAT4 - Fourth Satellite Parameters
All of the SAT4 parameters are set exactly the same way that the SAT1 parameters were set, but would be set
to different choices. Refer to the parameter setting information in the SAT1 – First Satellite Parameters
paragraphs to set PRESET, NAME, LON, RHCP freq, BAUD, FEC, and NID for a forth satellite that you wish to
use periodically.
3.3.8.
Access all of the SAT5 individual parameters via a sub menu. If a fifth SAVED satellite is not needed, preset
SAT5 to empty/blank so
NEXT will skip over this selection when you are switching satellites.
SAT5 - Fifth Satellite Parameters
All of the SAT5 parameters are set exactly the same way that the SAT1 parameters were set, but would be set
to different choices. Refer to the parameter setting information in the SAT1 – First Satellite Parameters
paragraphs to set PRESET, NAME, LON, RHCP freq, BAUD, FEC, and NID for a fifth satellite that you wish to
use periodically.
3.3.9.
Access all of the SAT6 individual parameters via a sub menu. If a sixth SAVED satellite is not needed, preset
SAT6 to empty/blank so
NEXT
will skip over this selection when you are switching satellites.
SAT6 - Sixth Satellite Parameters
All of the SAT6 parameters are set exactly the same way that the SAT1 parameters were set, but would be set
to different choices. Refer to the parameter setting information in the SAT1 – First Satellite Parameters
paragraphs to set PRESET, NAME, LON, RHCP freq, BAUD, FEC, and NID for a sixth satellite that you wish to
use periodically.
3.3.10.
Accessing the Factory Settings parameters should
ONLY
be done by a qualified technician from an
authorized Sea Tel dealer. The Antenna Model and Serial Number information is located on a sticker which
can be found on top of the electronics enclosure. The parameters are:
FACTORY SETTINGS
3.3.10.1. Serial Number
This parameter sets Serial Number of the Antenna Pedestal into the PCU memory. The serial
number starts with 98 followed by 6 digits that are editable. This parameter allows the serial number
of the antenna to be displayed on the display of the Antenna Control Panel during the initialization
process.
NOTE: The Serial Number parameter setting is saved in the PCU, therefore,
MUST be set whenever the PCU is changed.
After this parameter has been set correctly, it must be SAVED in the PCU.
1. Press the NEXT key to select this sub-menu parameter for adjustment.
2. A cursor will appear under the rightmost digit. Press
▼
&
▲
arrow keys to
increment/decrement this digit.
3. Press the
NEXT
key to move the cursor to the digit to the left. Press
▼
&
▲
arrow keys to increment/decrement this digit.
4. Continue editing until all 6 digits have been set to the correct Serial Number of
the antenna pedestal that this PCU is mounted on. Press the
SAVE
key to save
the Serial Number parameter.
5. Press
SAVE
again to exit the sub-menu and return to the FACTORY SETTINGS
main menu display. From there you can press the
▲
arrow key to go UP through
the SAT numeric menu choices.