Sea Tel ST14, Руководство по установке и обслуживанию

Страница: 28 / 84

Setup for Model ST14 D ST14 Ku-Band TVRO
2-8
NOTE: The Serial Number parameter setting is saved in the PCU, therefore,
MUST be set whenever the PCU is changed.
After this parameter has been set correctly, it must be SAVED in the PCU.
1. Press the NEXT key to SELECT this sub-menu parameter for adjustment.
2. A cursor will appear under the rightmost digit. Press
▼
&
▲
arrow keys to
increment/decrement this digit.
3. Press the
NEXT
key to move the cursor to the digit to the left. Press
▼
&
▲
arrow keys to increment/decrement this digit.
4. Continue editing until all 6 digits have been set to the correct Serial Number of
the antenna pedestal that this PCU is mounted on. Press the
SAVE
key to save
the Serial Number parameter.
5. Press SAVE again to exit the sub-menu and return to the FACTORY SETTINGS
main menu display. From there you can press the
▲
arrow key to go UP through
the SAT numeric menu choices.
2.3.11.2. MODEL CONFIGURATION
This parameter sets all of the internal drive, scale factor and limits for the motors, gear ratios and
sensors FOR THIS MODEL ANTENNA.
NOTE: The MODEL parameter setting is saved in the PCU, therefore, MUST be
set whenever the PCU is changed.
WARNING: Improper setting of this parameter WILL cause the antenna to
malfunction.
1. Press the NEXT key to select this sub-menu parameter for adjustment.
2. Once selected, press
▼
arrow to select the base model of either C14 or ST14
3. Then Press the
▲
arrow keys to scroll through a list of model configuration choices. The
current choices are blank, M, or D.
•
ST14/C14 : Single Receiver Configuration
•
ST14M/C14M:
Multiple receiver Configuration
•
ST14D/C14D:
DiSEqC compatible Configuration (Dish Network, Bell TV)
When the correct base model and model configuration value(s) are displayed, press the
SAVE
key to save to memory. As mentioned earlier this saves the drive, scale factors and limits
for this antenna.
If this parameter is
NOT set correctly
, the
antenna WILL
malfunction
.
2.3.11.3. LAT (Ships Latitude)
This parameter is automatically set by the GPS antenna mounted on the pedestal inside the radome.
The GPS input enables the antenna to quickly & accurately target satellites (SAT1 – SAT6).
1. Press the
NEXT
key to select this sub-menu parameter for adjustment.
2. A cursor will appear under the rightmost digit. Press
▼
&
▲
arrow keys to
increment/decrement this digit.
3. Press the
NEXT
key to move the cursor to the next digit to the left. Press
▼
&
▲
arrow
keys to increment/decrement this digit.
4. Press the
NEXT
key to move the cursor to the next character to the left. Press
▼
&
▲
arrow keys to toggle this character between N (North) and S (South).
Press the
SAVE
key to save the current ships latitude in the LAT parameter.