Schmitz 114.9600.0, Инструкция по эксплуатации, Страница: 17 / 88

Instructions for use arco-matic 200 M / 300 M - Version 2018-05-08 GBR ID no. 2038823A
17
Preparation for operation
Final mechanical works on the product are generally
performed by SCHMITZ u. Söhne or its distribution
partners. In so doing, the examination and treatment
chair must be levelled out, the foot section cladding
must be attached and the cradle of the hand control
unit must be mounted.
This chapter is intended for people who deal with the
fi nal mechanical works on the products. The fi nal mechanical works may be performed only
by personnel trained and authorised by SCHMITZ u.
Söhne or its distribution partners.
Performing the works described in this chapter
requires a spirit level, an M3 hexagon spanner, a
Phillips screwdriver, an M2.5 hexagon spanner and a
bar.
Levelling
The levelling feet serve to compensate for uneven
fl oors and to ensure that the examination and treat-
ment chair is placed in a horizontal position.

Lift the examination and treatment chair on one
side.

Secure the examination and treatment chair by
placing a bar under the foot section.

Turn the levelling foot in or out.

Remove the bar and lower the examination and
treatment chair.

Check to see if the examination and treatment
chair stands properly.
Repeat until the examination and treatment chair
stands properly.
NOTE
The power cord and supply cable for the foot control
unit may be damaged if the levelling screws touch
down on them.
For this reason, always make sure that none of
the electric cables are pinched under the levelling
screws or under the foot section.
Fig. 9
Lifting the examination and treatment chair
1) Front levelling foot (octagonal)
Fig. 10
Lifting the examination and treatment chair
1) Rear levelling foot