Safety instructions
6
Operating Manual ProNumeric XCI 600 Version 07/16
1
Safety instructions
The term automation systems includes control units, their components
(modules), other parts (such as racks, cables), operator panels, and the
software used for programming, commissioning and operating the control
units. This Operating Manual can only describe a part of the automation
system (e.g. modules).
The technical design of SCHLEICHER automation systems is based on the
EN 61131-2 (IEC 61131-2) product standard for programmable logic
controllers. The systems and devices are generally subject to CE marking
according to EMC Directive 2004/108/EC and, where applicable, the Low
Voltage Directive 2006/95/EC.
The Machinery Directive 98/37/EC or 2006/42/EC is not applicable, because
the safety objectives of the directive are covered by the Low Voltage and
EMC Directives.
When SCHLEICHER automation systems are part of the electrical
equipment of a machine, the manufacturer must include them in the
conformity evaluation process. In this case the DIN EN 60204-1 norm must
be observed (safety of machines, general requirements for electrical
equipment of machines).
When an automation system is properly maintained and used for its intended
purpose, it will not normally cause damage to property or present health
hazards. However, improper configuration, installation, maintenance or
operation of the system or machine, ignoring the instructions in this manual,
or intervention by insufficiently qualified personnel may result in connected
actuators (such as motors, hydraulic units, etc.) becoming a source of
danger.
1.1
Intended Use
SCHLEICHER automation systems are state-of-the-art products and
manufactured to recognised safety requirements. All the same, their use can
cause danger to the health and safety of operators and others, or damage
machines, systems or other property.
The automation system must only be used in technically flawless condition
and in compliance with its intended purpose, with attention given to safety
and hazards, and adherence to the Operating Manual. Correct transport,
storage and installation, operation and maintenance of the system are all
prerequisites for smooth and safe operation of the control unit. Malfunctions,
in particular those which may affect safety, must be immediately resolved.
Automation systems are designed exclusively to control machines and
systems. Any other application beyond this is not in compliance with the
intended use. The manufacturer will therefore accept no liability for any
damages resulting from the incorrect use of the systems.
When using automation systems, all instructions given in this manual
regarding mechanical and electrical setup, commissioning and operation
must be adhered to.
