SATO XL 410e, Руководство оператора, Страница: 75 / 80

Section 7: Optional Accessories
XL400/410e Operator’s Manual Page 7-1
7
OPTIONAL ACCESSORIES
7.1 INTRODUCTION
This section contains instructions for using the following XL Series optional features:
• Label Rewinder
• PCMCIA Memory Cards
• Calendar
• Stacker
7.2 LABEL REWINDER
The rewinder is an external unit that allows for labels and tags to be rewound in rolls up to 8.5
inches in diameter. The rewinder derives its power using a built-in cable connected directly to the
printer’s EXT connector. The rewinder facilitates the rewinding of tags/labels from the printer and
subsequently unwinds the media for use with applicators.
Installation
1. Position the Rewinder at the front of the printer and align it with the label slot. (The Rewind
Wheel/Spindle should be positioned away from the printer.)
2. Connect the built-in cable from the Rewinder to the EXT connector at the rear of the printer.
3. On the Rewinder, remove the metal clamp from the Rewind Spindle.
4. Feed the lead end of the label stock under the first spindle and onto the Rewind Spindle.
Feed the stock around the spindle once, then replace the metal clamp over the label stock.
Wind another revolution to ensure the labels are secure on the spindle.
5. Select the REWIND option on the rewinder, then set the power switch to ON. (The printer
must be powered ON for the rewinder to function.)
Removing and Unwinding the Roll
When labels are being printed, tension from the rewinder should keep the label stock taut as it
wraps itself on the spindle.
To remove the roll from the spindle, first set the power switch to OFF. Remove the metal clamp,
then remove the rewound roll of labels.
To unwind for using with an applicator, first set the power switch OFF. Attach the lead edge of the
labels from the rewind spindle to the applicator entry point. Select the WIND option on the
rewinder, and when ready to begin, set the power switch to ON.