SATO XL 410e, Руководство оператора, Страница: 44 / 80

Section 3: Configuration
Page 3-10 XL400/410e Operator’s Manual
7. The underline cursor is now positioned under the least significant digit of the H offset setting.
The horizontal offset will increase each time the START/STOP key is pressed. If the START/
STOP key is pressed and held down, the value will count up rapidly.
8. Once the correct setting is displayed, press the FEED key to accept the setting advance to
the next adjustment.
Zero Slash setting
This setting determines if a zero is printed with a slash or without a slash. This setting can also
be controlled via software commands. When YES is selected, the XU, XS, XM, XB, XL and
vector fonts will have a slash through the center of the zero character.
1. Use the START/STOP key to step the underline cursor to either the YES or NO selection.
2. Once the correct setting is underlined, pressing the FEED key will cycle back to the
Exit
You exit from the USER MODE by removing power from the printer. At this time the values
selected will be stored in non-volatile memory.
zero slash
Yes NO