SATO XL 410e, Руководство оператора, Страница: 50 / 80

Section 3: Configuration
Page 3-16 XL400/410e Operator’s Manual
3.5 SERVICE MODE (CONT’D)
1. Press the FEED key to enter the desired Service Mode.
2. Use the START/STOP key to select the type of media to be used.
3. Once the correct media type is shown in the display message, pressing the FEED
key will advance to the Backfeed Offset direction adjustment.
4. Use the START/STOP key to step the underline cursor to either the positive (+) or
negative (-) selection.
5. Once the correct direction setting is underlined, pressing the FEED key will
advance to the Backfeed Offset adjustment.
6. Use the START/STOP key to step the counter to the desired position. The display
increments one step for each time the START/STOP key is pressed. If the
START/STOP key is held pressed for more than two seconds, it automatically
goes into the fast scroll mode. The reading will advance to a setting of 99 dots
after which it automatically restarts at “00” again. The Backfeed Offset Direction
set in the previous step will be displayed in front of the Backfeed Offset setting.
Counter Clear
The Counter Clear Service Mode is used to reset the internal printer counters to
zero. This allows the user to keep track of the number of centimeters of label
material that has passed through the printer, as well as how many labels have
been dispensed, and how many labels have been cut.
The counters are identified in the display as:
NON: None (default)
ALL: Clears all counters
HEAD: Clears Head Counter
CUT: Clears
Cutter Counter
1. Press the FEED key to enter the desired Service Mode.
2. Use the START/STOP key to step the underline cursor to the counter(s) to be
reset. The default position is None (NON) of the counters. Use the START/STOP
key to advance the underline cursor to the desired position.
3. Once the correct setting is underlined, pressing the FEED key will clear the
selected counter and advance the display back to the SETUP SENSOR display.
Exit
To exit the Service Mode, turn off the printer. The settings will be stored in non-
volatile memory.
counter clear
non