
SATEL GSM-4/GSM-5
59
12. The rules for converting the numbers
If the calls are realized by the GSM module telephone, the telephone number received from
the control panel or a traditional telephone set is subjected to conversion still before being
sent over to the GSM module telephone.
1. When dialing the number, the module first checks if its initial digits are consistent with:
the pager station number (see: "PAGER tel. No" p. 28) – the conversion applies to the
digits following the pager station number and is limited to adding the prefix before
them, if it has been programmed (see: "Prefix for SMS" p. 28),
one of the programmed outgoing numbers (see: "Outgoing No. 1–4" p. 30) – the
conversion applies to the digits following the outgoing number,
the monitoring station telephone number (see: "MS1 tel.number / MS2 tel.number"
p. 43) – the number conversion is not applicable.
2. 4 seconds after dialing the last digit, the module proceeds to converting the number.
3. If the dialed number begins with a prefix to erase, the prefix is removed from the number.
4. If the dialed number does not begin with a prefix programmed in the module, a prefix
(prefix to add) can be put at the beginning of the number to be dialed.
5. If the dialed number begins with one of the fixed prefixes or has already been corrected,
the module will check if it is on the list of authorized numbers (see: "Tel.No 1-32 begin."
p. 30). If the number is on the list or the "Any numbers" (see: p. 28) option is enabled –
the number will be recognized as correct and the module will make the call.
13. Initiating the module firmware update by SMS message
Send to the
telephone number of GSM module an SMS message containing the control
command to start the module firmware update ("SMS firmware" function, "Firmware update"
submenu).
The
module will establish connection to the firmware update server whose
address is programmed in the module.
If the "Any address" option ("Firmware update" submenu) is enabled in the module, you can
send a message with the
xxxxxx=yyyy:zz.
or
xxxxxx=yyyy:zz=
content, where "xxxxxx" is
the control command used to start the update, "yyyy" is the address of server with the latest
firmware for the module (IP address or name), and "zz" is the server port number. The
module will connect to the computer whose address is given in the SMS message. If
the control command given in the SMS message is correct, and the other data are wrong, the
address and port of the server to which the module is to connect will be downloaded from
the settings programmed in the module.
After completion of the update, an SMS message containing information on the result of the
process and on the module firmware version will be sent to the telephone number from which
the SMS message initiating the firmware update was sent.
14. Restoring the factory settings
14.1 D
LOAD
10
program
1. Select the "Communication" command on the menu bar to open the menu.
2. Select the "Restore default settings" function in the menu. A window will be displayed in
which you are to confirm your intention to restore the module factory settings.